Archive

Archive for the ‘Fault Finding’ Category

Fault finding

When using the prototype boards I have encountered times when I have simply turned on the power and nothing has happened.  This is when fault finding comes into play to try and assess my circuits to find out what the problem is.  As there is no soldering involved the visual checks made are different to if I was checking a PCB.  On one of my first attempts I’m not quite sure what I did wrong but the 555 timer got extremely hot so the first check I make now is to see if any part of the circuit is over heating.  I need to be careful here because when I say hot I mean it could actually be enough to burn and there is the possibility that you might actually be able to smell burning.  Fortunately that has been a one off but due to the nature of the fact that it can become a safety hazard it is my first point of call.

Following this it is time to do the visual checks.  First and foremost double check the circuit, does it actually match the schematic if not make the alterations and try again.  Next I will make sure that everything is pushed in properly.  I don’t have the smallest of hands and some of the smaller wires can be tricky to get in and when working in a close knit space it is not uncommon to accidently knock out a wire while trying to insert another one.  Whilst doing this it is possible to see if any of the connections have snapped and of course if they have then they need to be replaced.  I am not adverse to putting components in the wrong way round occasionally, so the next thing to do is check that all polarised components such as leds ( long leg positive, smooth side negative) and capacitors are in the right way round, if not turn them round and try again otherwise the circuit will simply not work.  Whilst checking the components it is also important to check the values.  I purchased some transistors from Maplins, I had asked for BC547’S and what I actually received were BC557’S, sometimes components can be exchanged for a similar type but in this case when I checked the data sheet and although numerically similar one is a NPN and the other a PNP so the circuit was never going to work.  Finally one of my personal favorites was putting the IC in the wrong way round or even better just putting the wrong one in, it might sound daft but when concentrating on all the other things it is sometimes the most obvious that stump you.

By using the multimeter it is easier to actually see where the circuit may be faulty.  First check that the power supply is reading at the required voltage before testing components, and then I tend to follow the circuit round testing each individual component to see if they are receiving the correct amount of power.  By doing this you can see if a resistor is offering too much resistance and therefore swap it for a lower value etc

Categories: Fault Finding